Skip to product information
1 of 1

SKU:CS-GNG-200

Greystone CS-GNG-200 Solid core 30 Vac/dc switch, MOSFET, Go-No-Go, 0.75 amp trip

Greystone CS-GNG-200 Solid core 30 Vac/dc switch, MOSFET, Go-No-Go, 0.75 amp trip

Regular price $50.70 USD
Regular price Sale price $50.70 USD
Sale
Shipping calculated at checkout.

Greystone CS-GNG-200 is an AC current switch for Go/No Go load-status monitoring. Its factory-set trip point is 0.75 A. The normally open solid-state MOSFET output closes when monitored current exceeds the trip setpoint, providing an on/off signal to a controller rather than a proportional analog current measurement.

The sensor is self-powered by induction from the monitored AC line and requires no external power supply. It operates at 50/60 Hz with a typical response time of 200 ms. The output switch rating is 30 Vac/dc, 500 mA maximum; this is the switching-output rating, not an external power-supply requirement or a monitored-current trip range.

Mounting tabs secure the device inside a motor control panel using two #10 screws. The sensor uses a two-wire connection to the building automation system, and screw terminals accept 14-22 AWG wiring. Use insulated conductors only; the published insulation class is 600 Vac. Follow manufacturer installation instructions and applicable electrical safety procedures.

The sensing aperture is 20.3 mm (0.8 in). Specification-table dimensions are 67 x 68 x 24.1 mm (2.65 x 2.7 x 0.95 in). Enclosure material is ABS/polycarbonate with a UL94-V0 material rating. Operating conditions are -15 to 60 C (5-140 F) and 5-90% RH, non-condensing.

Applications include status monitoring for pumps, conveyors, lighting, heaters and fans. Current presence alone does not establish mechanical performance or identify a specific fault.

Product Literature

View full details