SKU:SC-GNG-200
Greystone SC-GNG-200 AC Current Switch, Split core 30 Vac/dc switch, MOSFET, 2 amp trip, Go - No - Go
Greystone SC-GNG-200 AC Current Switch, Split core 30 Vac/dc switch, MOSFET, 2 amp trip, Go - No - Go
Couldn't load pickup availability
Greystone SC-GNG-200 is a split-core AC current switch for Go/No Go load-status monitoring. Its factory-set trip point is 2 A. The normally open solid-state MOSFET output closes when monitored current exceeds the trip setpoint, providing an on/off signal to a controller rather than a proportional analog current measurement.
The switch is self-powered by induction from the monitored AC line and requires no external power supply. Maximum continuous input current is 200 A at 50/60 Hz. The output switch is rated for 30 Vac/dc and 500 mA maximum; these output ratings are separate from the monitored-current capacity. Typical response time is 200 ms.
The split-core design can be opened around an existing conductor without disconnecting the wire. Installation must follow manufacturer instructions and applicable electrical safety procedures. Use insulated conductors only; the published insulation class is 600 Vac. Mounting tabs secure the device inside a motor control panel using two screws. The datasheet specifies a two-wire connection to the building automation system.
Screw terminals accept 14-22 AWG wiring. The sensing aperture is 20.3 mm (0.8 in), and specification-table dimensions are 76 x 79 x 24.9 mm (3.0 x 3.1 x 0.98 in). The enclosure material is ABS/polycarbonate with a UL94-V0 material rating. Operating conditions are -15 to 50 C (5-122 F) and 5-90% RH, non-condensing.
Applications include status monitoring of AC loads such as pumps, conveyors, lighting, heaters and fans. A current-present signal does not by itself establish mechanical performance or a specific fault condition.
Product Literature
- Datasheet — Greystone SC-GNG-200 Datasheet
Share
